HP ProCurve 7102dl Reference Manual page 1227

SROS Command Line Interface Reference Guide
certificate ca <serial-number>
Use the certificate ca command to restore a CA certificate. Use the no form of this command to remove a
specific certificate from the certificate chain for a CA.
Syntax Description
<serial-number>
Default Values
No defaults necessary for this command.
Functional Notes
The user typically does not enter this command. It is primarily used to restore certificates from the startup
configuration when the product is powered up.
Usage Examples
The following example removes the CA certificate with the serial number 0712:
ProCurve(config)#crypto ca certificate chain MyProfile
ProCurve(config-cert-chain)#no certificate ca 0712
5991-2114
Specifies the certificate's serial number (up to 51 characters). This value can be
found for existing certificates by using the show run command.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
Certificate Configuration Command Set
1225