All Alignment And Align All Now - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings

All Alignment and Align All Now

IMPORTANT! It is recommended that you use
includes the individual alignment InstAlign
Burst Align
manual control over the individual alignments, then refer to the SA
Individual Alignment Control setting in
Chapter 30
The notification
amplitude alignment or channel equalization is stale (if its state is Hold)
and requires an update or it is in the OFF state. This situation does not
occur when the respective alignment is in the Auto state. To clear this
notification, press the Align All Now softkey.
How to set All Alignment and Align All Now
— Press Cal 5
— Then
— or
— Then
— Press Back
If you want to disable the All Alignment [Auto], you can do so in the FieldFox
preferences (i.e., you may want to do this, for example, if you are analyzing the
amplitude stability of a signal).
Refer to the SA Individual Alignment Control setting in
page
218
Now, and ChanEQ Align
System Settings.
AMPTD?
All Alignment [Auto]
Default is Auto.
Align All Now (to manually perform an Align All Now.) This performs
an alignment on all three individual alignments: Amptd Align Now, Burst
Align Now, and ChanEq Now). Refer to
page 219.
744, in Chapter 30 System Settings. See also,
Align All
Amptd Align
Now. But, if you would prefer to have
"Preferences" on page
displayed on screen means the InstAlign
(to enable or disable the All Alignment) –
"Individual Alignments" on
Keysight N9927-90020 User's Guide
Now, because it
Now, as well as,
744, in
"Preferences" on
"Individual Alignments".