Ip Igmp Snooping Mrouter - Dell C9000 Series Reference Manual

Version
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information The last-member-query-interval is also the interval between successive Group-Specific
Query messages. The ip igmp snooping last-member-query-interval
command allows you to change the last-member-query interval.

ip igmp snooping mrouter

Statically configure a VLAN member port as a multicast router interface.
C9000 Series
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter
interface interface command.
Parameters
interface interface
Defaults Not configured.
Command Modes
INTERFACE
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
Internet Group Management Protocol (IGMP) 1149