Programming Buttons & Settings; Programming Buttons, Programming Settings, Special Characters - Lucent Technologies Merlin Legend 7102 User Manual

Programming Buttons & Settings
If you use a feature often, you can program it onto an unused line button for easy access. If you use a
feature occasionally, see Using Features, p. 9. Keep these facts in mind when setting up your telephone:
• Some features must be programmed on a button or they can't be used. (These features are marked
with a on the Programming Codes list.)
• Other features (marked with • on the Programming Codes list) are settings that affect the way your
phone works. Some settings, such as Personalized Ring, affect all the lines on your phone. During
programming, you still have to select a line button, but it can be any line button the feature affects.
Others, such as Delay Ring for a single line, are settings that affect a specific line and require you to
press it during programming (these features are noted on the Programming Codes list). Settings
remain active until you program them again.
-Programming Buttons-
To program a feature on an unused line button:
1. Label a button for the feature.
2. Slide the T/P switch to P.
3. Press the button you labeled.
4. Dial the programming code (see Programming Codes).
5. Repeat Steps 3 and 4 to program other buttons. (Label the buttons first.)
6. Slide the T/P switch to center.
-Programming Settings-
To program a setting:
1. Slide the T/P switch to P.
2. Press any ICOM or SA button, OR
If the setting affects a specific line, press that line button.
3. Dial the programming code (see Programming Codes).
4. Repeat Steps 2 and 3 to program other settings.
5. Slide the T/P switch to center.
-Special Characters-
Features that dial numbers automatically may need special characters to allow for correct dialing or
system response.
Press... See... Means...
Drop s
Hold p
Conference f
# #
Copyright © 1996, Lucent Technologies. MERLIN LEGEND is a registered trademark of Lucent Technologies. Mirage,
StarSet, and Supra are registered trademarks of Plantronics, Inc.
Stop. Halts dialing sequence to allow for system response.
Pause. Inserts 1.5-sec. pause in dial sequence. Multiple consecutive pauses
allowed.
Flash. Sends switchhook flash. Must be first entry in sequence.
End of Dialing. Used to signal end of dialing sequence or to separate
grouped digits.
20