Pfc Commands; Clear Pfc Counters; Dcb-Input - Dell Force10 S4810P Reference Manual

Related dcb-policy input
Commands

PFC Commands

The following PFC commands are supported on the S4810 platform.

clear pfc counters

Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
S4810
Syntax clear pfc counters [port-type slot/port | stack-unit {unit
number | all } all stack-ports all}]]
Parameters
port-type
stack-unit
number
all stack-ports all
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.12.0
Version 8.3.16.0

dcb-input

Create a DCB input policy to apply pause or flow control for specified priorities using a configure delay time.
S4810
Syntax dcb-input policy-name
To delete the DCB input policy, use the no dcb-input command.
Parameters
policy-name
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
596
– applies the input policy with the PFC configuration to an ingress interface.
Enter the keywords port-type followed by the slot/port
information.
unit
Enter the keywords stack-unit followed by the stack-unit number
to be cleared.
Enter the keywords all stack-ports all to clear the counters
on all interfaces.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Maximum: 32 alphanumeric characters.
Introduced on the S4810.