Router Bgp - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.8.1.0
Version 7.7.1.0
Usage
You can use the redistribute command to advertise the IGP cost as the MED
Information
on redistributed routes. When you set the route-map with metric-type internal and
apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes. RFC does not support this
feature.

router bgp

To configure and enable BGP, enter ROUTER BGP mode.
S4810
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number
Defaults Not enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Border Gateway Protocol
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the AS number. The range is from 1 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Introduced on the S6000.
449