Match Interface - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

neighbor send-community

match interface

To match routes whose next hop is on the interface specified, configure a filter.

match interface interface

To remove a match, use the no match interface interface command.

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Access Control Lists (ACL)

— sends COMMUNITY attribute to peer or peer group.

Enter the following keywords and slot/port or number

information:

For the loopback interface, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel interface, enter the keyword port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

1 to 4094 (you can use IDs 1 to 4094).

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.