Extended Mac Acl Commands; Deny - Dell S6000 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.1.1.0
Usage
When you use the log option, the CP processor logs details about the packets that
Information
match. Depending on how many packets match the log entry and at what rate, the
CP may become busy as it has to log these packets' details.
Related

deny

Commands
permit

Extended MAC ACL Commands

When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit. The following commands configure Extended MAC ACLs.
The S6000 supports both Ingress and Egress MAC ACLs.
NOTE: For more information, also refer to the
MAC Access List Commands
deny
To drop packets that match the filter criteria, configure a filter.
S6000
Syntax
deny {any | host mac-address | mac-source-address mac-source-
address-mask} {any | host mac-address | mac-destination-address
Access Control Lists (ACL)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
Introduced on the E-Series.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
— configures a filter to drop packets.
— configures a filter to forward packets.
sections.
Commands Common to all ACL Types and Common
219