Permit (Standard Acls) - Dell 8 Command Reference Manual

10

permit (standard ACLs)

permit (standard ACLs)
Configures a MAC address rule to permit traffic based on the source MAC address.
Synopsis permit {MAC_ACL | any} [count]
no permit {MAC_ACL | any}
Operands MAC_ACL
any
count
Defaults By default, no MAC ACLs are configured.
Command Feature Access Control List Configuration mode
Modes
Description Use this command to configure rules to match and to permit traffic based on the source MAC
address. You can also enable counters for a specific rule. There are 255 ACL counters supported
per port group. Use the no permit command to remove a rule from the MAC ACL.
Usage There are no usage guidelines for this command.
Guidelines
Example To create a rule in a MAC standard ACL to permit traffic from the source MAC address
0022.3333.4444
To delete a rule from a MAC standard ACL:
See Also mac-access-list extended, no seq
150
Specifies the source host MAC address for which to set permit conditions.
Use the format HHHH.HHHH.HHHH.
Specifies any source MAC address.
Enables the counting of the packets matching the rule.
and to enable the counting of packets:
switch(conf-macl-std)#permit 0022.3333.4444 count
switch(conf-macl-std)#no permit 0022.3333.4444
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01