Extension Housing Seal And Bushing Replacement - Jeep 1987 Wrangler Workshop Manual

GEARBOXES
1*48
MODEL 231 TRANSFER CASE
Align and install the front propeller shaft.
Top off the transfer c a s e fluid with M e r c o n ®
transmission fluid.
EXTENSION HOUSING SEAL AND BUSHING
REPLACEMENT
N O T E : It is not n e c e s s a r y to remove the exten-
sion housing if only the seal is to be replaced.
The seal is readily accessible once the propel-
ler shaft and yoke have been removed.
Mark the rear propeller shaft yokes for a s s e m -
bly alignment reference.
Remove the rear propeller shaft.
Remove the extension housing bolts.
Remove the extension housing (2) by tapping it
in a clockwise direction.
CAUTION: Do not attempt to wedge or pry the
housing off the transfer c a s e . T h e sealing sur-
faces of both the housing and transfer c a s e
could be damaged in the process.
84283
Remove the housing seal by prying it out with a
screwdriver.
Remove the housing bushing with driver han-
dle J-8092 and remover J-33839.
28