TJ
REMOVAL AND INSTALLATION (Continued)
(3) Install new front bearing retainer gasket to the
front bearing retainer.
(4) Install the front bearing retainer onto the
transmission case.
(5) Install the bolts to hold the bearing retainer
onto the transmission case.
(6) Tighten the bolts to 17 N·m (12 ft. lbs.).
(7) Install release bearing and lever onto the
transmission.
EXTENSION HOUSING SEAL
REMOVAL
(1) Raise and support vehicle.
(2) Remove propeller shaft. Refer to Group 3, Dif-
ferential and Driveline, for proper procedures.
(3) Using a suitable seal puller or screw with a
slide hammer, remove the extension housing seal
(Fig. 12).
Fig. 12 Remove Extension Housing Seal
INSTALLATION
(1) Clean seal bore of extension housing of any
residual sealer material from original seal.
(2) Using Tool Handle C-4171 and Seal Installer
8212, install new extension housing seal so that the
seal is located 0
0.5 mm (0
of the extension housing (Fig. 13).
(3) Install propeller shaft. Refer to Group 3, Differ-
ential and Driveline, for proper procedures.
(4) Check and add fluid to transmission as neces-
sary. Refer to the Recommended Lubricant section for
proper fluid requirements.
(5) Lower vehicle.
0.02 in.) to the face
TRANSMISSION AND TRANSFER CASE
Fig. 13 Install Extension Housing Seal
ADAPTER HOUSING SEAL
REMOVAL
(1) Hoist and support vehicle.
(2) Remove transfer case.
(3) Using a suitable pry tool, or a slide hammer
mounted screw, remove the adapter housing seal
(Fig. 14).
Fig. 14 Remove Adapter Housing Seal
INSTALLATION
(1) Clean seal bore of adapter housing of any
residual sealer material from original seal.
(2) Using Tool Handle C-4171 and Seal Installer
8208, install new seal so that the seal is located 0
0.2 mm (0
0.008 in.) to the seal bore face of
adapter housing (Fig. 15).
21 - 7