Extension Housing Seal; Adapter Housing Seal - Jeep Wrangler 1997 Manual

TJ
REMOVAL AND INSTALLATION (Continued)
(6) Tighten the bolts to 17 N·m (12 ft. lbs.).
(7) Install release bearing and lever onto the
transmission.

EXTENSION HOUSING SEAL

REMOVAL
(1) Raise and support vehicle.
(2) Remove propeller shaft. Refer to Group 3, Dif-
ferential and Driveline, for proper procedures.
(3) Using a suitable seal puller or screw with a slide
hammer, remove the extension housing seal (Fig. 12).
Fig. 12 Remove Extension Housing Seal
INSTALLATION
(1) Clean seal bore of extension housing of any
residual sealer material from original seal.
(2) Using Tool Handle C-4171 and Seal Installer
8212, install new extension housing seal so that the
seal is located 0 0.5 mm (0
of the extension housing (Fig. 13).
Fig. 13 Install Extension Housing Seal
(3) Install propeller shaft. Refer to Group 3, Differ-
ential and Driveline, for proper procedures.
(4) Check and add fluid to transmission as neces-
sary. Refer to the Recommended Lubricant section for
proper fluid requirements.
0.02 in.) to the face
TRANSMISSION AND TRANSFER CASE
(5) Lower vehicle.

ADAPTER HOUSING SEAL

REMOVAL
(1) Hoist and support vehicle.
(2) Remove transfer case.
(3) Using a suitable pry tool, or a slide hammer
mounted screw, remove the adapter housing seal
(Fig. 14).
Fig. 14 Remove Adapter Housing Seal
INSTALLATION
(1) Clean seal bore of adapter housing of any
residual sealer material from original seal.
(2) Using Tool Handle C-4171 and Seal Installer
8208, install new seal so that the seal is located 0
0.2 mm (0 0.008 in.) to the seal bore face of
adapter housing (Fig. 15).
Fig. 15 Install Adapter Housing Seal
21 - 7