STEERING AND FRONT AXLE
STEERING COLUMN SERVICE
1
2
*3
4
5 6
S E E
I.S.
N
O
T
E
S
84693A
Remove the hazard warning switch knob. Press
the knob inward and turn it counterclockwise to
remove it.
Remove the turn signal/wiper lever by pulling it
straight out of the column.
Disconnect the turn signal switch wire harness
connector (7) from the bracket at the lower end
of the steering column.
Attach a fish wire to the switch harness and tape
the harness (A) to prevent snagging during
removal.
84694
Remove the turn signal switch attaching screws
(8) and actuator arm (9).
Remove the turn signal switch (10). Pull the
switch and wire harness straight up and out of
the housing. Use the fish wire to help guide the
harness up and out of the housing.
Remove the wiper switch harness and any
additional harnesses from the column.
8
101490
G-32