Valve Body Without Lock-Up - Jeep 1987 Wrangler Workshop Manual

AUTOMATIC TRANSMISSIONS
OVERHAUL
Install the fail-safe valve (7) and spring (8) into
the housing.
Install the lockup valve (5) and spring (6) into the
housing.
Install the end plate and attaching s c r e w s (4).
Install lockup module housing (3) and oil tube (1)
to the valve body (2).
Install attaching s c r e w s .
Install the oil filter.
Measure the throttle and line pressure settings.
NOTE: If p r e s s u r e s were satisfactory before
disassembly, do not change the line or throttle
pressure adjusting s c r e w settings.
Valve Body Without Lock-Up
Disassembly
CAUTION: Do not clamp any part of the valve
body or transfer plate in a v i s e . Any slight
distortion of the body or plate will c a u s e sticking
v a l v e s or e x c e s s i v e leakage or both. When
removing and installing valves or plugs, slide
them in or out very carefully. Do not u s e force to
remove or install valves.
Remove the oil filter attaching s c r e w s (A) and oil
filter (B).
NOTE: T h e oil filter s c r e w s are longer than the
transfer plate s c r e w s .
84476
Remove the transfer plate a s s e m b l y retaining
s c r e w s and remove the transfer plate a s s e m b l y
(1).
Remove the s c r e w s attaching the stiffener and
s e p a r a t o r p l a t e s to the transfer plate a n d
separate these parts.
S E E
I.S.
N
O
T
E
S
NOTE: W h e n disassembling the valve body,
identify all valve springs with a tag for assembly
reference.
29