ELECTRICAL
INTERIOR LIGHTING SYSTEM
BACKUP LAMP SWITCH -
MANUAL TRANSMISSION
The backup lamp switch (A) is threaded into the
right rear corner of the transmission cover
housing (B).
The backup lamp switch is actuated by the
reverse shift rail.
The backup lamp switch is NOT S E R V I C E -
A B L E OR A D J U S T A B L E and must be replaced
as a unit.
BACKUP LAMP SWITCH -
AUTOMATIC TRANSMISSION
A combination backup and neutral safety switch
(A) is mounted on the steering column. THIS
SWITCH IS ADJUSTABLE.
NOTE: If the backup lamp switch is defective,
the switch must be replaced.
To adjust the backup lamp switch, place the
transmission shift lever in the R E V E R S E
position.
Loosen the two switch attaching screws (B). Do
not remove them completely.
Turn the ignition switch to the ON position.
Rotate the switch one direction or the other until
the backup lamps operate.
Tighten the attaching screws.
Check the switch for an engine start in the
NEUTRAL and PARK positions.
S E E
I.S.
N
O
T
E
S
101358
A. Unit Power
B. Backup Lamp Switch
C. Harness Assembly
C-125