Jeep 1987 Wrangler Workshop Manual page 1603

m
G
THROTTLE BODY FUEL INJECTION SYSTEM
m
G
m
G
2.0L ENGINE
m
G
Installation
C o n n e c t the r e p l a c e m e n t relay to the wire
h a r n e s s connector.
Throttle Body Assembly
Removal
R e m o v e the air inlet bonnet (A) and spacer (B).
Disconnect the:
• throttle cable
• throttle return spring
• cruise control cable (if equipped)
• wire h a r n e s s connector from the injector (A)
• wire h a r n e s s connector from the T P S (B)
• wire h a r n e s s connector from the ISA motor ( C )
• fuel supply pipe (D) from the throttle body
• fuel return pipe (E) from the throttle body
Disconnect the vacuum h o s e s from the throttle
body assembly. Identify and tag the h o s e s for
installation reference.
R e m o v e the throttle body-to-manifold retaining
bolts ( F ) .
R e m o v e the throttle body a s s e m b l y from the
intake manifold.
If the throttle body assembly is being replaced,
t r a n s f e r the following c o m p o n e n t s to the
r e p l a c e m e n t throttle body: I S A motor a n d
bracket assembly.
101789
131