Jeep 1987 Wrangler Workshop Manual page 815

STEERING AND FRONT AXLE
STEERING COLUMN SERVICE
Remove the ignition lock cylinder retaining
screw (13) and pull the lock cylinder (14) out of
the upper housing (15).
100476B
NOTE:
If the wiper switch is being removed with
the column out of the vehicle, continue with the
disassembly procedure. However, if the column
is still in the vehicle, prepare the switch for
removal a s follows: L o o s e n the column
mounting bracket bolts about 3-4 turns. Mark or
tag the switch wires for assembly reference.
Compress the wire lock tabs (A) with a drill bit or
straight pin and push the wires (B) out of the
connector (C) with a drill bit or straight pin.
1 0 1 4 9 5
Remove the ignition switch (16) and dimmer
switch (17) from the column jacket.
84698A
G-45