NOTE: This will give access to the MCU harness
(D), the two-terminal connector (E), and the
jumper wire (F).
103826
8. Remove the jumper wire (F) from the two-
terminal connector (E).
NOTE: DO NOT DISCARD THE JUMPER
WIRE. Place the jumper wire in the glove com-
partment for reinstallation when the vehicle is
returned to operation ABOVE 4,000 feet.
9. Tape the two-terminal connector to the MCU
harness.
10. Install the radio.
12. Connect the battery ground cable.
13. Connect the idle decel switch to the
carbuetor spark port as follows:
• Remove the idle decel switch-to-carburetor
E G R port vacuum hose (1).
NOTE: The idle decel switch is located behind
and to the left of the cylinder head cover.
11. Install the radio bezel.
9