Jeep 1987 Wrangler Workshop Manual page 1127

ELECTRICAL
6 CYLINDER STARTER MOTOR
Remove the overrunning clutch (14) and frame
(15) from the armature (16).
2641
Remove the screws attaching the end cover
(17) to the armature. Remove the cover but do
not remove the brush holder plate.
Remove the brush feed wire (18) by sliding the
wire and wire connector out of the shield (17).
2642
Install a 22mm socket (19) on the armature
shaft.
Slide the socket up against the armature com-
mutator. Then slide the brush holder (20) onto
the socket (19). Leave the socket in position in
the brush holder for inspection and assembly.
2643
Remove the seal ring (21) from the planetary
gear assembly (22).
Remove the planetary gears (23).
Remove the gear carrier and pinion shaft from
the planetary annulus gear.
Place a 17mm socket (24) on the workbench.
Then position the planetary gear/overrunning
clutch assembly (25) in a vertical position (on
end), so the entire assembly rests on the
socket.
Unseat the stop ring (26) using a 12 point 14mm
socket (27). Position the socket on the pinion
shaft and against the stop ring (26). Then strike
the socket with a hammer to unseat the stop
ring and expose the snap ring.
1
5