Quick-Connect Fuel Lines - Jeep 1987 Wrangler Workshop Manual

mG
THROTTLE BODY FUEL INJECTION SYSTEM
m G mG
2.0L ENGINE
m G
Disconnect the fuel supply, return and vent
h o s e s .
Turn the fuel gauge sending unit retainer ring
with a screwdriver and remove.
Separate the sending unit (B) and pump ( C ) .
B . Sending Unit
C . Fuel Pump
82079A
Installation
Connect the fuel pump (C) to the sending unit
(B).
Install the sending unit/pump assembly in the
tank and secure with the retaining ring.
Connect the h o s e s .
Install the tank with the retaining bolts.
Connect the wire harness connector.
Connect the battery cables.
N O T E : T h e fuel tank is e q u i p p e d with a
pressure/vacuum filler c a p .
Quick-Connect Fuel Lines
T h e 2.0L engines utilizes quick-connect fuel line
couplings for the fuel supply and return lines to
the throttle body assembly.
T h e quick-connect fuel lines are located near
t h e right strut t o w e r b e h i n d t h e e n g i n e .
W h e n e v e r the q u i c k - c o n n e c t fuel lines a r e
d i s c o n n e c t e d , the O-rings in the connector
should be replaced. U s e the quick-connect fuel
line O-ring replace-ment procedure.
Connect the fuel filler tube to the tank.
134