Table of Contents
Advertisement
ELECTRICAL
CRUISE CONTROL
Attach the cable housing to the mounting studs.
Make sure that the housing hole is aligned over
the servo hole.
SPEED SENSOR REMOVAL
NOTE: The speed sensor is located above the
front drive shaft and is in-line with the
speedometer cable.
Unscrew the two attaching nuts from the speed
sensor.
Disconnect the wire lead from the cruise
harness.
101488
A. Tach Generator Assembly
B Speedometer Tube Shaft (LWR)
C . Upper Servo Cable Assembly
SPEED SENSOR INSTALLATION
Plug in the speed sensor.
Screw on the two supporting nuts.
SERVO CASLE REMOVAL
Remove the lock clip and washer from the pin on
the bellcrank.
Remove the lost motion link.
Squeeze the tabs that retain the cable housing
in the bracket.
Remove the cable from the bracket.
Remove the cable housing from the servo.
Remove the cable clip from the servo cable.
SERVO CABLE INSTALLATION
Attach the cable clip to the servo.
Install the cable housing on the servo.
N O T E : The mounting studs are not equally
spaced from the hole in the servo. Ensure the
housing is installed correctly.
Attach the cable housing on the bracket. Ensure
the tabs are locked in the bracket.
Place the lost motion link on the bellcrank pin.
Install the washer and lock clip.
S E E
I . S .
N
O
T
E
S
C-140
Advertisement
Table of Contents
Troubleshooting
