Table of Contents
Advertisement
ELECTRICAL
WINDSHIELD WIPERS
WIPER ARM INSTALLATION
Push the wiper arm over the pivot shaft.
Pull back the wiper arm.
Remove the Continuity Test Lamp J-21008-A,
or ice pick-type tool.
CAUTION: Be sure the pivot shaft is in the
PARK position and the wiper arm is positioned
correctly on the windshield.
DRIVER SIDE
6.3 cm
(2
1
/
2
in)
P A S S E N G E R SIDE
7.9 cm (3Ve in)
841295A
PIVOT SHAFT BODY AND LINKAGE REMOVAL
Remove the left and right wiper arms.
Remove the nuts attaching the pivots to the
windshield frame.
R e m o v e the n e c e s s a r y hard or soft top
components from the windshield frame.
Remove the left and right windshield holddown
knobs and fold the windshield forward.
Remove the left and right access hole covers.
Disconnect the wiper motor drive link from the
left wiper pivot.
Remove the pivot shaft body and linkage
through the access hole.
PIVOT SHAFT BODY AND
LINKAGE INSTALLATION
Install the pivot shaft body and linkage in the
windshield frame.
Connect the wiper motor drive link to the left
wiper pivot.
Install the left and right access hole covers.
Raise the windshield to the upright position and
install the left and right windshield holddown
knobs.
Install the nuts attaching the pivots to the
windshield frame.
Install the left and right wiper arms.
Install the necessary top components on the
windshield frame.
C-130
Advertisement
Table of Contents
Troubleshooting
