Jeep 1987 Wrangler Workshop Manual page 1130

ELECTRICAL
6-CYLINDER STARTER MOTOR
• Check snap ring-to-stop ring alignment. If
necessary, tap the snap ring with a screw-
driver until aligned in the stop ring.
• Tighten the puller tool to seat the stop ring
(35) on-and-over the snap ring.
2649
Inspect the pinion shaft bushing surface (36)
after installing the snap and stop rings. Remove
small burrs or scratches on this surface with
crocus cloth or 400-600 grit sandpaper.
Lightly lubricate the bushing in the overrunning
clutch housing with S A E 20W oil.
Install the clutch fork (37) on the overrunning
clutch (38).
2650
Install the planetary/overrunning clutch assem-
bly in the overrunning clutch housing (39).
Be sure the locating lugs (40) on the planetary
annulus are properly aligned and seated in the
housing.
2651
18