Jeep 1987 Wrangler Workshop Manual page 856

STEERING AND FRONT AXLE
POWER STEERING GEAR
Install the needle bearing (34) in the housing
(11) with tools J 21551 and J 8092. Install the
b e a r i n g in the h o u s i n g bore until it is
approximately 0.76 mm (0.030 in) below the
shoulder of the bore.
84780A
Start the single lip inner seal (33) and a backup
washer (35) into the housing bore.
Push the seal and washer into the housing bore
with tool J 21553. Install the seal and washer
only far enough to provide clearance for the
remaining seal, backup washer and retaining
ring.
CAUTION: Do not bottom the seal against the
end of the housing counterbore.
3 6 —
35—^C35
35 —*^S>
Install the double lip seal and remaining backup
washer with tool J 21553. Install the seal and
backup washer into the bore only far enough to
allow clearance for the retaining ring.
G-86