Gauge Cluster Installation; Instrument Panel Gauge Removal And Installation; Clock Removal; Clock Installation - Jeep 1987 Wrangler Workshop Manual

ELECTRICAL
INSTRUMENT PANEL
G A U G E CLUSTER I N STALLATI O N
Plug in the wire harness connector.
Install the six cluster screws (E).
Install the six bezel screws (A).
I N S T R U M E N T PANEL G A U G E R E M O V A L
NOTE: This procedure is to be performed with
the gauge cluster removed.
Remove the plastic shield (M). Release the
seven plastic tabs with a screwdriver.
Remove metal shield (L).
Completely remove gauge nut (A).
A
C o A
Q
£—W
7
§ 3
o o o o
M
A. Gauge Nut(s)
B. Gauge Contact Pins
C. Clock Screw(s)
D. Contact Spring(s)
E. Gauge Housing Mounting Screws
F. Coolant Temperature Gauge
G. Fuel Gauge
H. Clock
J . Oil Pressure
K. Voltmeter
L. Metal Shield
M. Plastic Shield
I N S T R U M E N T PANEL G A U G E I N STALLATI O N
Insert gauge into gauge housing.
Place gauge contact pins (B) over gauge screw.
The gauge contact pins (B) will automatically be
driven into gauge when gauge nut (A) is
tightened.
Install metal shield (L).
Install plastic shield (M).
CLOCK R E M O V A L
N O T E : This procedure is to be performed with
the gauge cluster removed.
Remove plastic shield (M). Release the seven
plastic clips with a screwdriver.
Remove metal shield (L).
Remove clock mounting screws (C).
NOTE: Contact springs (D) may fall out if gauge
cluster is not held upright.
Remove clock from gauge housing.
CLOCK I N STALLATI O N
Make sure contact springs are in position (D).
101334
Place clock (H) into gauge housing (E).
Install the clock mounting screws (C).
Install metal shield (L).
Install plastic shield (M).
C-153