Compressor Clutch - Jeep 1987 Wrangler Workshop Manual

HEATING AND AIR CONDITIONING
AIR CONDITIONING SYSTEM
SEE
I.S.
N
O
T
E
S
COMPRESSOR CLUTCH
The compressor clutch consists of a stationary
electromagnetic coil and a rotating pulley and
plate assembly. The pulley and plate are mount-
ed on the compressor shaft.
'/Vhen the compressor is not operating, the pul-
m freewheels on the clutch hub bearing. When
the coil is energized, the plate is magnetically
angaged with the pulley and turns the compres-
sor shaft.
i s m o w a l
Assert two pins of Front plate spanner J 29635
^to any two bolt holes in the front clutch plate.
84430
Hold the clutch plate stationary and remove the
nut.
Remove the clutch plate using puller J 29636
and remove the key from the shaft.
J 29636
S4431
Remove the internal bearing snap ring.
Remove the external front snap ring.
Remove the rotor pulley assembly with puller J
29637.
J 29637
84432
Insert the lip of the puller jaws into the internal
bearing snap ring groove.
L-38