Jeep 1987 Wrangler Workshop Manual page 1053

HEATING AND AIR CONDITIONING
AIR CONDITIONING SYSTEM
Coat the seal retainer with clean compressor oil
and install it with retainer tongs J 9393-2. Press
the retainer lightly against the seal.
81077A
Install the snap ring with the beveled edge out
(away from the compressor). Lightly tap the
snap ring to seat it in if necessary.
Install the clutch spacer shims.
Tap the replacement felt ring into place and in-
stall the compressor shaft key.
Align the front plate keyway with the compres-
sor shaft key.
Install the front plate. Use clutch face installa-
tion tool J 29641 to tap the front plate onto on
the shaft until it contacts the clutch shims.
J 29641
84439
Install and tighten the pulley nut to 34-41 N»m
(25-30 ft-lbs)torque.
Check the air gap around the perimeter of the
plate with a feeler gauge. The air gap must be
between 0.41 and 0.79 mm (0.016 and 0.031 in).
86923
If the air gap is not consistent around the pe-
rimeter of the plate, pry up lightly at the areas of
L - < •47