Jeep 1987 Wrangler Workshop Manual page 1310

AUTOMATIC TRANSMISSIONS
2%uk
H)
OVERHAUL
mm
Assembly
Position the pump housing on a smooth flat
surface and install the pump rotors.
NOTE: New rotors may be installed with either
f a c e up. U s e d rotors must be installed a s
removed. Refer to reference marks made during
disassembly.
Align and install the reaction shaft support on the
pump housing and finger-tighten the attaching
bolt.
Insert two Slide Hammers J-6585-1 and Bolts
J - 7 0 0 4 - 3 , from the back to the front, into the
threaded reaction shaft support holes. T h e bolts
should be threaded into the support until the
ends of bolts are 1.6 mm (1/16-inch) below front
machined surface of pump housing (A).
.J-7004-3
84499
84500
Install one Pilot Stud Tool J - 3 3 8 7 - 2 into the c a s e
pump opening.
Install the pump assembly backward into the
c a s e opening. T a p the pump gently to s e a t it in
the c a s e .
Tighten the bolts attaching the reaction shaft
support to the pump housing to 19 N-m (160
in-lbs) torque.
R e m o v e the pump and reaction shaft support
assembly from the c a s e .
Remove the slide hammer tools from the pump.
Position the oil seal in the pump housing with the
seal lip facing inward.
Install the s e a l using Installer Tool J - 9 6 1 7 .
Install the seal into the housing until the tool
bottoms.
50