Table of Contents
Advertisement
Pig.
16
17. O n J e e p models, install carrier seal using
tool 5080.
H U B AID BEARING CARRIER INSTALLATION -
EAGLE MODELS
1. Thoroughly clean axle shaft (20) (Fig. 2) and
apply a thin coating of lithium grease. Install
axle shaft-to-bearing spacer (18) (Fig. 2).
2. Install rotor shield (16) to the bearing carrier
(10) and hub (6), (Fig. 2). Coat o-ring (11) with
grease and install it to the carrier assembly.
3. Apply Locktite, 312 9800, and install the
three carrier bolts (17) (Fig. 2) tighten bolts
to 102 N-m (75 ft.-lbs.).
4. Install caliper anchor plate to the steering
knuckle. Tighten bolts to 136 N-m (100 ft.-
lbs.) torque.
7. Install washer (4), axle nut (3) and tighten
to 237 N-m (175 ft.-lbs.) torque (Fig. 2).
8. Install nut retainer (2) and cotter pin (1), (Fig.
2).
NOTE: Do not loosen the nut to fit the retainer.
Tighten the nut to the next available slot.
9. Install wheel and tire assembly.
10. Lower vehicle.
HUB A N D BEARING CARRIER INSTALLATION -
JEEP MODELS
1. Thoroughly clean axle shaft (20) (Fig. 2) and
apply a thin coating of lithium grease.
2. Install rotor shield (16), bearing carrier (10)
and hub (6), (Fig. 2).
3. Apply Locktite, 812 9800, and install the
three carrier bolts (17) (Fig. 2). Tighten bolts
to 102 N-m (75 ft.-lbs.) torque (Fig. 2).
4. Install disc brake rotor and caliper.
5.
Install washer (4), axle nut (3) and tighten
to 237 N-m (175 ft.-lbs.) torque (Fig. 2).
6. Install nut retainer (2) and cotter pin (1),
(Fig. 2).
7. Install wheel and tire assembly.
8. Lower vehicle.
5. Connect steering arm to steering knuckle.
Tighten bolts to 136 N-m (100 ft.-lbs.) torque.
6. Install disc brake rotor and caliper.
9
Advertisement
Table of Contents
Troubleshooting
