Jeep 1987 Wrangler Workshop Manual page 989

BRAKE SYSTEM
BRAKE SYSTEM SERVICE
84043
Install the top (5) and bottom (8) anti-rattle
springs.
101350
Install the inboard brake pad (7) and the out-
board brake pad (6).
101362
Check position of the anti-rattle springs (5) and
(8). Be sure they are seated and the spring ends
in contact with the pad mounting ears.
CAUTION: Avoid damaging the caliper piston
dust boot when installing the caliper. If the boot
is cut or torn, the piston will be exposed to dirt
and moisture from normal road splash.
Install the caliper on the anchor plate.
Install the caliper mounting pins (3).
Clean and remove the master cylinder cover.
Fill the master cylinder reservoirs to the speci-
fied level.
Pump the brake pedal several times to seat the
brake pads. Then top off the master cylinder
reservoirs and install the cover.
Install the wheels and lower the vehicle.
SEE
I.S.
N
O
T
E
S
17