Check Ball Size Chart - Jeep 1987 Wrangler Workshop Manual

AUTOMATIC TRANSMISSIONS
OVERHAUL
Install the check balls (A) (B) in the valve body
( C ) .
Install the rear clutch c h e c k ball (D) in the
transfer plate and the rear servo apply c h e c k ball
( E ) on all 900 series transmissions.
Install the pressure regulator valve s c r e e n (F) in
the separator plate (G).
Position the separator plate on the transfer plate
(4).
84471
Position the transfer plate assembly on the valve
body and install the retaining s c r e w s finger-tight.
N O T E : Before tightening the retaining s c r e w s
be sure the pressure regulator filter s c r e e n and
10 mm ( 3 / 8 - i n c h ) diameter c h e c k ball a r e
properly aligned.
Starting at the center and working outward,
tighten the transfer plate a s s e m b l y retaining
s c r e w s to 4 N-m (35 in-lbs) torque.
84472
Check Ball Size Chart
A = 11/32 I n c h D i a m e t e r
B = 1/4 I n c h D i a m e t e r
84473
S E E
I.S.
N
O
T
E
S
2 5