Air Intake Deflector Installation - Jeep 1987 Wrangler Workshop Manual

6. Using Ditzler DP40/401, S i k k e n s Washpri-
mer or Sherwin Williams E2Y36, prime bare
metal areas exposed by drilling holes. After
applying primer, apply an enamel top coat
and allow it to dry.
7. Position splash shield and install it using
panel fasteners (Fig. 1). P u s h the rear end
of shield in behind shock absorber bracket
(L-Fig. 1).
8. Position the other front splash shield to the
left wheelhouse using the brake hose a s a
locator.
9. Mark the center of the top splash shield
holes. Do not mark the two lower holes at
the frame (C-Fig. 1). T h e s e holes are not
used on the driver side shield.
10. Remove splash shield and center punch
the five top hole locations. Using a 7 mm
(9/32 in.) drill bit, drill the five holes into the
wheelhouse.
Note: B e c a r e f u l w h e n drilling h o l e s
through the wheelhouse into the engine
compartment. K e e p drill from contacting
components inside the engine compart-
ment.
11 Using Ditzler DP 40/401, Sikkens Washpri-
mer, or Sherwin Williams E 2 Y 3 6 , prime
bare metal a r e a s exposed by drilling holes.
After applying primer, apply an enamel top
coat and allow to dry.
12, Position splash shield and install it using
panel fasteners. P u s h rear end of the shield
behind the shock absorber bracket.
13. Install both front wheels and tires.
Air Intake Deflector Installation
1. Remove left headlamp trim ring.
2. Remove headlamp and headlamp bucket.
3. Open hood and remove the two top s c r e w s
from the ambient air duct attached to the
radiator support.
4. Reaching through the headlamp opening,
install the ambient air duct deflector, PN
8953 005 120, using two s c r e w s and nuts
provided in the kit (D, E - F i g . 2). Install
screws from the headlamp side to provide
clearance for the headlamp bucket.
5. Install headlamp bucket and headlamp.
6. Install headlamp trim ring.
E
1850
Fig.
2
14. Lower vehicle.
2