Programming From A Multiline Terminal - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Description
System Programming can be performed from any display multiline terminal. Most programming changes
become effective immediately. Other programming changes become effective after the data is backed up
from temporary memory to permanent memory.
Conditions
You can have up to two telephones in programming mode anytime.
You can have a maximum of four users logged into WebPro anytime.
You can have four WebPro users and two phone programming users logged in all at the
same time for a total of six users in programming mode simultaneously. However, the two
phone programming users do not show up in session management in WebPro.
PCPro can be logged in with only one user. This is allowed only if no other users are logged
into programming mode (PCPro, WebPro, or Phone). Also, if a user is connected to the
switch via PCPro, no other user can log in through PCPro, WebPro, or Phone Programming.
Programming from a multiline terminal can require a password to enter programming.
Temporary License can be activated only from a Multiline Terminal, not PCPro or WebPro.
When activated, the system is temporarily licensed for ACD, CTI, Firmware Upgrade,
Hotel, 256 MEGACO stations, and SMDR.
Each time the temporary license is activated, the program is read only until the
temporary license expires.
Each time the temporary license expires, it can be set again for up to 10 additional
days.
After setting a number of days in the program, subsequent days show one less as it
counts down to expiration.
When Program 90-37-01 shows 1, the license expires at midnight on that day. When
the license expires, the system resets.
If the date is changed in Program 10-01-01 while the temporary license is in effect, one
day is subtracted from the license period.
If the date is changed in Program 10-01-01 when the temporary license shows 1 day,
the system resets when it is applied (Transfer), not when exiting programming mode.
Default Setting
Enabled
SV8100 Features and Specifications Manual

Programming from a Multiline Terminal

Issue 1.0
2 - 863