NEC Univerge SV8100 Features And Specifications Manual page 721

UNIVERGE SV8100
the system to be properly assigned.
Program
Program Name
Number
14-05-01 Trunk Group – Trunk Group
Number
14-06-01 Trunk Group Routing – Priority
Order Number
14-07-01 Trunk Access Map Setup
15-01-02 Basic Extension Data Setup –
Outgoing Trunk Line Preference
15-02-10 Multiline Telephone Basic Data
Setup – Ringing Line Preference
for Trunk Calls
SV8100 Features and Specifications Manual
Description/Comments
For Auto-Answer of Non-Ringing
Lines, assign trunks to trunk
groups. This is part of Trunk
Group Routing programming.
Used to set the priority order
number 1~4.
For Outgoing Line Preference and
Auto-Answer of Non-Ringing Lines,
set up the Trunk Access Maps.
Turns On (1) or Off (0) Outgoing
Trunk Line Preference for
extensions.
Enable Idle (0) or Ringing (1) Line
Preference for trunk calls. Program
22-01-01 sets Intercom (0) or trunk
(1) call priority.
Assigned Data
Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order)
0 = Not Specify1~100 :
(Trunk Group
Number)1001~1100 :
(1000 + Route Table
Number)
Default:
Route 1, Order Number 1
= 1 (Trunk Group 1)
Order Numbers 2, 3, 4 =
0 (Not Specified)
All Other Routes (2~100)
and Order Numbers
(1~4) = 0 (Not Specified)
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when
trunk on Hold
4 = Outgoing access and
access when trunk on
Hold
5 = Incoming access and
access when trunk on
Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk on
Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is on
Hold).
0 = Off
1 = On
(default = 0)
0 = Idle
1 = Ringing
(default = 1)
Issue 1.0
Level
1 2 3
2 - 697