NEC Univerge SV8100 Features And Specifications Manual page 1211

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
11-02-01 Extension Numbering
14-02-09 Analog Trunk Data Setup – Busy
Tone Detection
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
SV8100 Features and Specifications Manual
Description/Comments
Set the systems internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this program
to tailor the system numbering to
the site.
Caution
Improperly programming this option
can adversely affect system
operation. Make sure you
thoroughly understand the default
numbering plan before proceeding.
Before changing your numbering
plan, use PCPro or WebPro to
make a backup copy of your
system data.
Set the extension number. The
extension number can be up to
eight digits long. The first/second
digit(s) of the number should be
assigned in Program 11-01-01.
This allows an employee to move to
a new location (port) and retain the
same extension number.
Used to Enable or Disable busy
tone detection for trunk ports.
Used to define a analog trunk as
Loop Start or Ground Start.
Assigned Data
Refer to UNIVERGE
SV8100 Programming
Manual
Up to eight digits
1 101
2 102
3 103
~ ~
99 199
100 3101
~ ~
512 3513
0 = Disable
1 = Enable (default)
0 = Loop Start (default)
1 = Ground Start
Issue 1.0
Level
1 2 3
2 - 1187