NEC Univerge SV8100 Features And Specifications Manual page 1374

Issue 1.0
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
Use this key...
Code: 37
Operation: Call
extension + Press
key
Code: 38
Operation: Leave
message: Call ext +
Press key OR
Answer message:
Press key
Code: 39
Operation: Press
key at destination
and source + ext
Code: 40
Operation: Press
key
Code: 41 + sec. ext.
Operation: Press
key
Code: 42 + boss
ext.
Operation: Press
key
Code: 43
Operation: TRK call
+ Hold + ext + Press
key
Code: 44
Operation: Place or
answer call + Press
key
Code: 45
Operation: Place or
answer call + Press
key
Code: 46
Operation: Press
key
Code: 47 + dest.
ext.
Operation: Press
and hold key
3 - 34
press the key and enter the code (e.g., 48 for Voice Over).
For this feature...
Call Forwarding / Do
Not Disturb Override
Message Waiting
Room Monitor
Handset Cutoff
Secretary Call
Serial Call
Hold
Department Calling
Reverse Voice Over
When you are...
Overriding an extension's
Call Forwarding or Do Not
Disturb
Answering/Leaving a
Message Waiting
Activating Room Monitor
Cutting off the handset
transmission while on a
call
Calling your secretary
(using the buzzer)
A secretary picking up a
call ringing your boss's
extension.
Placing a Serial Call to a
co-worker
Putting a call on System
Hold (if hold key is
reassigned)
Putting a call on Exclusive
Hold
Logging in or logging out
of your Department
Calling Group
Initiating Reverse Voice
Over
UNIVERGE SV8100
Also see
Key Lamp Status
Srvc Code
On red when
activated
None
Fast Flash red at
destination, Hold
Flash red at
source
On when feature
active (no
transmission on
handset)
On red at source
Fast Flash red at
destination
On red when
activated
None
None
None
On when
removed, Off
when installed
Full BLF red
Codes Tables
707
0
or
0
-
-
-
-
-
-
-
650
-