NEC Univerge SV8100 Features And Specifications Manual page 1057

UNIVERGE SV8100
Program
Program Name
Number
51-01-02 Net-Link System Property Setting
– Primary Candidate Order
51-01-03 Net-Link System Property Setting
– Secondary System Flag
51-02-01 Net-Link System Individual
Setting – System Name
51-02-02 Net-Link System Individual
Setting – Time Zone (Hour)
51-02-03 Net-Link System Individual
Setting – Time Zone (Minute)
51-02-04 Net-Link System Individual
Setting – Authenticate System
MAC Address
51-03-01 Net-Link Internet Protocol
Address List Setting – Internet
Protocol Address List
SV8100 Features and Specifications Manual
Description/Comments
When the Primary system is turned
off or disconnect from network, this
value is used to select a new
Primary system. Smaller number is
higher priority.
If this value is the same number, the
System ID (Program 51-01-01) is
referred, and the system which has
the smaller number is selected as
Primary system.
0: NetLink is dynamically
established based on Node List in
PRG51-03-01. Primary System will
be selected in the order which the
system wakes up.
1: The system will connect with Top
Priority Primary System. If Top
Priority Primary System was not
found, the system will search
Primary System like this setting is 0.
This is the name given to each
system.
Determines the time offset from the
Primary system.
(0 = -12, 1 = -11, 2 = -10.... 24 = +12)
This setting affects Time Display on
MLT (see 51-13-02).
Determines the time offset from the
Primary system.
(0 = -60, 1 = -59, 2 = -58.... 120 =
+60)
This setting affects Time Display on
MLT (see 51-13-02).
To use this function, set Program 51-
13-03 to 1 (enable), Net-Link
systems will reject the connection
from unauthenticated system
access.
The system seeks the Primary
system based on this list.
When there is no Primary system
yet, or Fail Over occurs, Node List is
referred to establish new link. This
setting is necessary when Program
51-01-03 is 0, or Program 51-05-02
is other than 0.
Once the system connects to the
Primary System, this setting is
updated by the Primary system
when Program 51-13-01 is On. So,
enter IP address of the systems
which may become Primary at least.
Assigned Data
1~50
(default = 30)
0 = Disable
1 = Enable
(default = 0)
Up to 20 characters.
(default not assigned)
0~24
(default = 12)
0~120
(default = 60)
00-00-00-00-00-00~
FF-FF-FF-FF-FF-FF
(default =
00-00-00-00-00-00)
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.255.255.254
192.0.0.1 ~
223.255.255.254
(default = 0.0.0.0)
Issue 1.0
Level
1 2 3
2 - 1033