NEC Univerge SV8100 Features And Specifications Manual page 1068

Issue 1.0
When the battery is low during standby, the Talk/Batt.low LED blinks (On 50 msec., Off 50
msec.).
When the battery is low during a call, an alarm tone is generated, and the Talk/Batt.low LED
blinks (On 50 msec., Off 50 msec.). The Handset must be returned to the Base Unit.
The battery is charged by the line voltage.
Only one Handset Cordless terminal can be connected per ESI port.
A provided RF line cord should be used for best performance.
The Handset Cordless is a stand-alone terminal.
Base units of the Handset Cordless terminals should be installed at least 17 feet apart for
optimum performance. The distance range between the Base Unit and the handset is
30~100 feet without obstructions, depending on the environment.
Distance of DTP-16HC-1( ) from the switch is 60 Meters (197 feet). Condition is less than 10
ohms loop resistance. Maximum distance when ACA-U Unit is connected, is 330 meters
(1,083 Feet). Condition is less than 57 ohms loop resistance.
The Handset does not ring when the battery is low.
The standard charged nickel-cadmium battery may last four hours for conversation and 40
hours for standby. Initially the battery must be charged without interruption for 17.5 hours.
The charge LED (below the Base Unit contacts) is red during charging and remains on after
charging is completed.
After continuous charging, the Handset battery may fail to charge or discharge quickly. In
either case, operate the Handset until the low battery alarm sounds, auto shutoff occurs, and
the battery is fully discharged. Charge the battery without interruption for 17.5 hours. When
the battery no longer charges, replace it.
The ACA-U Unit is the only adapter that can be used for the Handset Cordless Terminal.
Using the ACA-U Unit minimizes normal display blanking when the cordless handset is returned
to the Base Unit.
term
The D
Depending on your environment, the maximum number of cordless devices used without
interference varies.
Multiple base and handset units should not be closer than 20 feet anytime.
Radio interference causes interruptions in conversation. When this happens, your unit is not
defective. When noise continues, move to a different location while you talk. (You might
even need to move the Base Unit.) When the situation persists, contact NEC Unified
Solutions, Inc., National Technical Assistance Center (NTAC).
When adding an 8LK module to a 12 button phone, the first key on the 8LK module is button
25.
Default Setting
None
2 - 1044
Handset Cordless is not wall mountable.
UNIVERGE SV8100
SV8100/SV8300 Terminals