NEC Univerge SV8100 Features And Specifications Manual page 422

Issue 1.0
Program
Program Name
Number
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
20-01-05 System Options – DTMF Receive
Active Time
20-06-01 Class of Service for Extensions
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
20-14-01 Class of Service Options for
DISA/E&M – First Digit
Absorption (Delete First Digit
Dialed)
20-14-02 Class of Service Options for
DISA/E&M – Trunk Group
Routing/ARS Access
2 - 398
Description/Comments
If DISA caller can place outgoing
calls through the system (refer to
Program 20-14 in the UNIVERGE
SV8100 Programming Manual),
enable loop supervision (1) for the
DISA trunk. If DISA caller cannot use
the system trunks for outgoing calls,
enter 0 to disable loop supervision.
After answering the call, the system
attaches a DTMF receiver to the
DISA trunk for this time.
Assign a Class of Service (1~15) to
an extension.
Turns Off or On the extension ability
to receive a second call from a DID,
DISA, DIL, or tie line caller.
With this option set to 1, the
destination extension must be
busy for a second DNIS caller
to ring through. If the destination
extension does not have a trunk
or CAP key available for the
second call and a previous call
is ringing the extension but has
not yet been answered, the
second caller hears busy
regardless of this program
setting.
Select whether an extension should
display the reason a call is being
transferred to their extension (Call
Forward Busy, Call Forward No
Answer, DND).
For tie lines, Enable or Disable the
ability to absorb (ignore) the first
incoming digit. Use this to make the
tie trunk compatible with
3- and 4-digit tie line service. This
option does not apply to DISA.
This option Enables or Disables a
DISA or tie trunk caller ability to dial 9
for Trunk Group Routing or
Automatic Route Selection (ARS).
UNIVERGE SV8100
Assigned Data
0 = Disable
1 = Enable
(default = 1)
0~64800 (seconds)
(default = 10 seconds)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
Direct Inward System Access (DISA)
Level
1 2 3