NEC Univerge SV8100 Features And Specifications Manual page 786

Issue 1.0
Program
Program Name
Number
81-11-07 Tie Line Initial Setup – Length of
Wink Signal Selection
81-11-08 Tie Line Initial Setup – Length of
Delay Signal Selection
81-11-09 Tie Line Initial Setup – Incoming
Interdigit Timeout Selection
81-11-10 Tie Line Initial Setup – Wink/
Delay Signal Detect Timeout
Selection
81-11-11 Tie Line Initial Setup –
Disconnect Recognition Time
Selection
81-11-12 Tie Line Initial Setup – Automatic
Release Signal Detection
Selection
Operation
None
2 - 762
Description/Comments
Specify the time a wink pulse is
sent to another system.
Specify the time a delay pulse is
sent to another system.
Specify the time, in seconds, that
an address signal is missing
during the incoming call detection
process before an error tone is
returned to the other system.
Specify a maximum time, in
seconds, for receiving an
acknowledgment signal from a
distant system before sending a
busy tone.
Specify the minimum time before a
disconnected circuit can be
accessed again.
Specify the signal detection time
for release of a Tie Line after a
disconnect signal is received from
the distant Central Office or PBX.
UNIVERGE SV8100
Assigned Data
0~15
(30 ms~480 ms)
[default = 5 (180 ms)]
1~15
(300 ms~4.5 seconds)
(0 = No Setting)
[default = 1 (300 ms)]
0 = 8
1~15
(1~15 seconds)
[default = 6 (6 seconds)]
0 = 8
1~15
(1~15 seconds)
[default = 7 (7 seconds)]
1~15
(0.1~1.5 seconds)
(0 = No Setting)
[default = 3 (0.3
seconds)]
1~14
(50~700 ms)
15 = (No Limit)
(0 = No Setting)
[default = 7 (350 ms)]
Multiple Trunk Types
Level
1 2 3