NEC Univerge SV8100 Features And Specifications Manual page 748

Issue 1.0
Waiting indication if the called party uses Handsfree Answerback. The system cancels the
indication only if the called party lifts the handset or presses Speaker.
With the Hotel/Motel set up, an employee with a multiline terminal can send a Message
Waiting to a room telephone if allowed in system programming.
A Message Waiting key simplifies this feature operation.
Telephone-to-telephone Message Waiting works when the voice mail is installed.
The MW (Message Waiting) LED may be used to indicate voice mail messages if no
extension number is assigned to the voice mail key in system programming.
If the following programs are changed while the phone is online, a reset of the feature is
required before the setting takes effect.
Program
Program
Program
Program
If both Voice Mail Message and Message Wait indication is set, the color set for Message
Wait overrides the color used for Voice Mail Message indication.
Default Setting
Enabled
System Availability
Terminals
All Terminals
Required Component(s)
None
2 - 724
15-02-35 Message Waiting Lamp Cycle for Calling Extension
15-02-36 Message Waiting Lamp Cycle for Called Extension
15-02-37 Voice Mail Message Wait Lamp Color
15-02-38 Voice Mail Message Wait Lamp Cycle
For example, if a message waiting was set before any of these programs were changed, the lamp
remains the same until the message waiting is set again.
UNIVERGE SV8100
Message Waiting