NEC Univerge SV8100 Features And Specifications Manual page 408

Issue 1.0
Program
Program Name
Number
25-07-05 System Timers for VRS/DISA –
Duration Time for Guidance
Message by Automatic
Answering Telephone Set
25-07-06 System Timers for VRS/DISA –
Duration Time for Guidance
Message by ACI
25-07-11 System Timers for VRS/DISA –
VRS/DISA Answer Delay Time
25-07-13 System Timers for VRS/DISA –
VRS/DISA Busy Tone Interval
25-07-14 System Timers for VRS/DISA –
Delayed VRS Answer Time
34-01-01 E&M Tie Line Basic Setup –
DID/E&M Start Signaling
34-01-02 E&M Tie Line Basic Setup –
Receive Dial Type for E&M Tie
Line
Direct Call by Time Schedule
Program
Program Name
Number
11-10-35 Service Code Setup (for
Administrator) – Dial-In Mode
Switching
15-07-01 Programmable Function Keys
20-07-26 Class of Service Options
(Administrator Level) – Dial-In
Mode Switch
2 - 384
Description/Comments
Set the announcement time of the
automatic answering extension
before an incoming DID trunk caller
is disconnected.
Set the announcement time by the
ACI before an incoming DID trunk
caller is disconnected.
Set the time the system waits after
receiving an incoming VRS/DISA
call before the system automatically
answers the call.
If a DISA caller dials a busy
extension (and Program 25-04-01 =
0), the system plays busy tone for
this time before disconnecting.
Assign the delay time from switching
from a normal incoming status to
DID mode. If this time is set to 0, the
call switches to DID mode
immediately.
Set the start signaling mode for DID
and tie trunks. DID and tie trunks can
use either immediate start or wink
start signaling.
For DID and tie trunks, use this
option to set the trunks signaling
type (Dial Pulse or DTMF).
Description/Comments
Assign the service code Dial-In
Mode Switching.
Assign a function key for one-touch
access to the Dial-In Mode
Switching setup code (Code 88).
Enable (1) or Disable (0) an
extension ability to manually change
Dial-In Modes.
UNIVERGE SV8100
Assigned Data
0~64800 (seconds)
(default = 10 seconds)
0~64800 (seconds)
(default = 10 seconds)
0~64800 (seconds)
(default = 0 seconds)
0~64800 (seconds)
(default = 5 seconds)
0~64800 (seconds)
(default = 10 seconds)
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 2)
Related Programming
10-09
0 = DP
1 = DTMF
(default = 1)
Assigned Data
MLT, SLT
(default not assigned)
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
(Appearance
00 ~ 99
Function Code) (Service
Code 752 by default)
0 = Off
1 = On
(default = 0 for
COS 1~15)
Direct Inward Dialing (DID)
Level
1 2 3
Level
1 2 3