NEC Univerge SV8100 Features And Specifications Manual page 1271

UNIVERGE SV8100
Operation
Calling Your Mailbox
To call your mailbox:
With a multiline terminal, your Voice Mail key flashes green and your Message Center keys flash red
when they have messages waiting. If you do not have a Voice Mail key, your Message Waiting LED
flashes instead.
Multiline Terminal
1. Press your Voice Mail key (Program 15-07 or SC 751: 01 + 8).
- OR -
Press the Vmsg softkey.
- OR -
Press the Message key on the telephone, if equipped.
Your mailbox number is normally the same as your extension number. You may optionally dial a co-worker's
mailbox - or use this procedure to call your mailbox from a co-worker's telephone.
- OR -
Press Speaker and dial 8.
2. If requested by Voice Mail, enter your security code.
Ask your Voice Mail system administrator for your security code.
Normally, your Message Waiting (MW) LED goes out (if applicable). If it continues to flash, you have unanswered
Message Waiting requests or a new General Message. See "To check your messages" below.
Single Line Telephone
1. Lift the handset and dial 8.
If you are at a co-worker's telephone, you can dial the Voice Mail master number and your mailbox number
instead. You can also use this procedure from your own telephone to call a co-worker's mailbox.
2. If requested by Voice Mail, enter your security code.
Checking Messages
If Program 15-02-26 = 0 (Message Key):
1. Press the Message key once.
The user can use the VOL UP and VOL DOWN keys to view the new messages. If there are both voice mail
messages and Message Waiting calls, the display indicates the number of new voice mail messages and then each
Message Waiting call is shown.
When there are new messages, the Message Waiting LED on the telephone will flash red.
To return a displayed Message Waiting, press the Speaker key or lift the handset.
SV8100 Features and Specifications Manual
Issue 1.0
2 - 1247