NEC Univerge SV8100 Features And Specifications Manual page 542

Issue 1.0
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
11-02-01 Extension Numbering
11-04-01 Virtual Extension Numbering
11-06-01 ACI Extension Numbering
11-07-01 Department Group Pilot Numbers
– Dial
11-08-01 ACI Group Pilot Number
11-09-01 Trunk Access Code
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
11-10-01 Service Code Setup (for System
Administrator) – Night Mode
Switching
11-10-03 Service Code Setup (for System
Administrator) – Setting the
System Time
11-10-04 Service Code Setup (for System
Administrator) – Storing
Common Speed Dialing Numbers
2 - 518
Description/Comments
Customize the system internal
(Intercom) numbering plan.
Assign extension numbers to
extension ports. The telephone
programming identity follows the
port number – not the extension
number.
Assign virtual extension numbers.
Use to define the virtual extension
number to be used for the ACI
extension numbering.
Use to assign pilot numbers to
each Department Group set up
Use to assign the pilot number to
the ACI Groups set in Program
33-02.
If required, change the single-digit
Trunk Access Code (normally 0). If
you change this code, you must
also review the settings in Program
11-01-01 for the new code
selected.
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Use to customize the night mode
switching Service Codes for the
System Administrator.
Use to customize the system time
Service Codes for the System
Administrator.
Use to store common speed
dialing Service Codes for the
System Administrator.
UNIVERGE SV8100
Assigned Data
1
Refer to Univerge
SV8100 System
Program Manual
Up to eight digits
1 101
2 102
3 103
~ ~
99 199
100 3101
~ ~
512 3513
Up to eight digits
1 201
2 202
3 203
~ ~
99 299
100 3601
~ ~
256 3757
ACI Ports: 1~96
(default not assigned)
Up to eight digits
(default not assigned)
ACI Groups: 1~16
(default not assigned)
Dial (up to four digits)
(default = 0)
Dial (up to four digits)
[default not assigned)]
MLT,SLT
(default = 718)
MLT
(default = 728)
MLT
(default = 753)
Flexible System Numbering
Level
2 3