NEC Univerge SV8100 Features And Specifications Manual page 662

Issue 1.0
Program
Program Name
Number
14-05-01 Trunk Group – Trunk Group
Number
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
21-19-01 IP Trunk (SIP) Calling Party
Number Setup for Extension
22-02-01 Incoming Call Trunk Setup
44-02-01 Dial Analysis Table for ARS/F-
Route Access – Dial
44-02-02 Dial Analysis Table for ARS/F-
Route Access – Service Type
2 - 638
Description/Comments
Assign trunks to trunk groups then
go to Program 14-06-01 below to
set up Trunk Group Routing.
This program assigns the Caller
Party Number for each IP trunk.
The assigned number is sent to
the central office when the caller
places an outgoing call. If the
Calling Party Number is assigned
by both Program 21-17 and
Program 21-18/ 21-19, the system
uses the entry in Program 21-18/
21-19.
This program is used to assign the
Calling Party Number for each
extension. The assigned number
is sent to the central office when
the caller places an outgoing call.
If the Calling Party Number is
assigned by both Program 21-17
and Program 21-18/Program
21-19, the system uses the data in
Program 21-18/Program 21-19.
Assign the incoming trunk type for
each trunk.
Set the Dial digits for the Pre-
Transaction Table for selecting
ARS/F-Route (eight digits max:
#
1~9, 0 , @). To enter a wild
card/don't care digit, press Line
Key 1 to enter an @.
Set the Service Type (0~3) for the
Pre-Transaction Table for
selecting ARS/F-Route.
IP Trunk – (SIP) Session Initiation Protocol
UNIVERGE SV8100
Assigned Data
Trunks 1~200
Trunk Port 1~200,
Group 1,
Priority 1~200
Up to 16 Digits
#
(1~0, , )
(default not assigned)
Up to 16 Digits
#
(1~0, , )
(default not assigned)
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
Level
1 2 3