NEC Univerge SV8100 Features And Specifications Manual page 661

UNIVERGE SV8100
Program
Program Name
Number
10-30-04 SIP Authentication Information –
Authentication Trial
10-36-01 SIP Trunk Registration
Information Setup – Registration
10-36-02 SIP Trunk Registration
Information Setup – User ID
10-36-03 SIP Trunk Registration
Information Setup –
Authentication User ID
10-36-04 SIP Trunk Registration
Information Setup –
Authentication Password
10-37-01 UPnP Setup – UPnP Mode
10-37-02 UPnP Setup – Retry Time
10-40-01 IP Trunk Availability – IP Trunk
Availability
10-40-02 IP Trunk Availability – Number of
Ports
11-01-01 System Numbering – Service
Code
14-01-24 Basic Trunk Data Setup –
Trunk-to-Trunk Outgoing Caller
ID through Mode
14-02-01 Analog Trunk Data setup –
Signaling Type (DP/DTMF)
SV8100 Features and Specifications Manual
Description/Comments
Define the Authentication Trial.
When a call tries to register with
the SIP carrier and they refuse,
this entry determines how many
times the UNIVERGE SV8100
sends authentication.
Enable or Disable the SIP trunk
registration.
Used to define the USER ID for
the SIP Trunk.
Used to define the Authentication
USER ID for the SIP Trunk.
Use to define the Authentication
Password for the SIP Trunk.
Use to Enable or Disable UPnP.
Define the retry time for UPnP.
Use to Enable or Disable IP
Trunks.
Define the number of IP Trunks
when enabled.
Set the system internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this
program to tailor the system
numbering to the site.
Enable (1) or Disable (0) the ability
to send the original Caller ID
through when the call is Forward
Off-Premise.
At default, Program 14-02-01 is
set to 2 (DTMF). For the IAD
trunks this must be set for Dial
Pulse [either 0 (10PPS) or 1
(20PPS)].
Assigned Data
0~9
(default = 1)
0 = Disable
1 = Enable
(default = 0)
Up to 32 Characters.
(default not assigned)
Up to 64 Characters.
(default not assigned)
Up to 32 Characters.
(default not assigned)
0 = Disable
1 = Enable
(default = 0)
0,60 ~ 3600
(1~59 cannot be input)
(default = 60)
0 = Disable
1 = Enable
(default = 0)
0 ~ 128
(default = 0)
Refer to System
Numbering Default
Settings table in the
UNIVERGE SV8100
Programming Manual for
a list of default settings.
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
Issue 1.0
Level
1 2 3
2 - 637