NEC Univerge SV8100 Features And Specifications Manual page 588

Issue 1.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-11-15 System Numbering – Enable
Handsfree Incoming Intercom
Calls
11-11-16 System Numbering – Force
Ringing of Incoming Intercom
Calls
11-12-06 Service Code Setup (for Service
Access) – Switching of Voice
Call and Signal Call
15-02-16 Multiline Telephone Basic Data
Setup – Handsfree Operation
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
20-06-01 Class of Service for Extensions
2 - 564
Description/Comments
If required, change the service code
used for setting an extension to
voice announce for incoming ICM
calls.
If required, change the service code
used for setting an extension to
forced ringing for incoming ICM
calls.
If required, change the service code
used for toggling an outgoing ICM
call between a voice call and signal
call.
Enable (1) or disable (0) ability of
an extension to use the
speakerphone on outside calls.
When disabled, users can hear the
conversion, but cannot respond
handsfree.
Use this option to enable (1) or
disable (0) Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
Assign a Class of Service (1~15) to
an extension.
Handsfree Answerback/Forced Intercom Ringing
UNIVERGE SV8100
Assigned Data
1
MLT
(default = 721)
MLT
(default = 723)
MLT, SLT
(default = 712)
0 = Disable
1 = Enable
(default = 1)
0 = Disable (Voice)
1 = Enable (Signal)
(default = 1)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension
ports = Class 1
Level
2 3