NEC Univerge SV8100 Features And Specifications Manual page 1221

UNIVERGE SV8100
Program
Program Name
Number
16-01-07 Department Group Basic Data
Setup – Call Recall Restriction for
STG
16-01-09 Department Group Basic Data
Setup – Department Hunting No
Answer Time
16-01-10 Department Group Basic Data
Setup – Enhanced Hunt Type
16-02-01 Department Group Assignment
for Extensions
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
22-02-01 Incoming Call Trunk Setup
22-07-01 DIL Assignment
SV8100 Features and Specifications Manual
Description/Comments
Determine whether or not an
unanswered call transferred to a
Department Group should recall the
extension from which it was
transferred.
Set how long a call rings a
Department Group extension
before hunting occurs.
Set the type of hunting for each
Extension (Department) Group.
Set up the Department Group
called by the pilot number and the
extension priority when a group is
called.
Call Pickup Groups are set up in
23-02.
Turns Off (0) or On (1) an extension
user ability to use Continued
Dialing, which allows DTMF signal
sending while talking on extension.
Assign Service Type 4 to each
trunk you want to ring into the
Multimedia Conference Bridge as a
Direct Inward Line (DIL).
Assign the master/pilot number of
the Conference group from
Program 11-07-01 as the DIL
destination. If all Conference ports
are in the same unique Extension
(Department) Group (see Program
16-02 above), the DIL will ring
another Conference port if its
assigned port is busy.
Assigned Data
0 = Disable (Recall)
1 = Enable (No Recall)
(default = 0)
64800 (seconds)
(default = 15 seconds)
0 = No queuing
1 = Hunting When Busy
2 = Hunting When Not
Answered
3 = Hunting When Busy
or No Answer
(default = 0)
Department Groups
1-64
Priority 1-512
Default = All extensions
in Department Group 1
with priority in port
order:
Port 1 priority = 1
Port 512 priority = 512
0 = Off
1 = On
(default = 1 for
COS 1~15)
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Extension Number
(maximum eight digits)
(default not assigned)
Issue 1.0
Level
1 2 3
2 - 1197