Ip Trunk - H.323 - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Program
Program Name
Number
20-09-02 Class of Service Options
(Incoming Call Service) – Caller
ID Display
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
21-18-01 IP Trunk (H.323) Calling Party
Number Setup for Extension – IP
Trunk (H.323) Calling Party
Number Setup for Extension
22-02-01 Incoming Call Trunk Setup
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
SV8100 Features and Specifications Manual
Description/Comments
Turns Off (0) or On (1) the Caller ID
display at an extension.
This program assigns the Caller
Party Number for each IP trunk.
The assigned number is sent to the
central office when the caller places
an outgoing call. If the Calling Party
Number is assigned by both
Program 21-17 and Program 21-18/
21-19, the system uses the entry in
Program 21-18/21-19.
Use to assign the Calling Party
Number for each extension. The
assigned number is sent to the
exchange when the caller places an
outgoing call.
Assign the incoming trunk type for
each trunk.
Set the number of digits to be
analyzed by the system for ARS
routing.
Set the Service Type (0~3) for the
Pre-Transaction Table for selecting
ARS/F-Route.
Assigned Data
1
0 = Off
1 = On
(default = 1 for
COS 1~15)
Up to 16 Digits
#
(1~0, , )
(default not assigned)
Up to 16 digits
#
(1~0, , )
(default not assigned)
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
Issue 1.0
Level
2 3
2 - 649