NEC Univerge SV8100 Features And Specifications Manual page 1218

Issue 1.0
Related Features
None
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit Setup
10-55-01 Package Network Setup – IP
Address
10-55-03 Package Network Setup – Main/
Add-on
2 - 1194
Description/Comments
Assign at least one circuit for DTMF
reception (type 0 or 1). Use the
following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate
one DTMF receiver for every
five devices that use them.
Use to define the IP Address for the
CD-ETIA.
When the blade is deleted
from the system using
Program 90-05, the
programming for the slot in
10-55 is set back to default.
The Main setting is to be utilized to
distribute an IP Address to the
blade.
UNIVERGE Multimedia Conference Bridge
UNIVERGE SV8100
Assigned Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.255255.254
192.0.0.1 ~
223.255.255.254
(default = 172.16.1.100)
0 = Main
1 = Add-on
(default = 1)
Level
1 2 3